Applad White Kitchen - "Phase 1"
Posted Dec 27th, 10 at 3:48 pm by arosso
These are some of the pictures for phase 1:
The oven cabinet is a standard 88" high cabinet. At the bottom (out of the picture), I managed to fit a full hight drawer (the middle drawer from a 30" 4 drawer cabinet). The oven (a GE Profile PT956) fit perfectly. The bottom drawer is flush to the bottom of the oven and the top doors fit just right. The only small detail was that since the top of the oven is rounded rather than straight I had to cut a few little 1/2" fillers to cover the gaps.
The OTF cabinet is a 30"x24" which has been cut down to 30"x18" and I'm using the 15"x18" doors. Fits pretty nicely (the gap over the fridge is 34.5". I'm planning on making one of those wine rack mods using some of the cover panels to fill in that 4" gap that is left.
The oven cabinet is a standard 88" high cabinet. At the bottom (out of the picture), I managed to fit a full hight drawer (the middle drawer from a 30" 4 drawer cabinet). The oven (a GE Profile PT956) fit perfectly. The bottom drawer is flush to the bottom of the oven and the top doors fit just right. The only small detail was that since the top of the oven is rounded rather than straight I had to cut a few little 1/2" fillers to cover the gaps.
The OTF cabinet is a 30"x24" which has been cut down to 30"x18" and I'm using the 15"x18" doors. Fits pretty nicely (the gap over the fridge is 34.5". I'm planning on making one of those wine rack mods using some of the cover panels to fill in that 4" gap that is left.
Total Comments 0
